Repair of electrical equipment of the engine VAZ-1111 Oka

In this section, articles about the device and repair of electrical equipment of the engine of the VAZ-1111 Oka car.

Features of the battery device
Main battery for VAZ-1111 cars; -11113 is 6ST-36A. But 6ST-35A and 6ST-44A batteries can also be used. The 6ST-36A battery consists of six series-connected elements with a voltage...

Possible faults of the battery
Possible battery malfunctions, their causes and solutions. Accelerated battery discharge during vehicle operation Generator drive belt slippage - Adjust belt tension. Generator...

Bringing a dry-charged battery into working condition
Spare parts for batteries are supplied (mostly) without electrolyte in a dry-charged version. To bring such a battery into working condition, remove the technological plugs or...

Keeping the battery in good working order
Checking the electrolyte level The electrolyte level should be between the "MIN" and "MAX" marks on the translucent battery case. During battery operation, the electrolyte level...

Features of the generator device
Generator type (model) 37.3701 — alternating current, three-phase, with a built-in rectifier unit and electronic voltage regulator. The same generator is used in VAZ-2108 cars....

Rules for checking and operating the generator
When operating, servicing and repairing the generator, the following rules must be observed, violation of which may result in damage to the voltage regulator or rectifier valves...

Possible generator faults
Possible generator malfunctions, their causes and solutions. The indicator lamp does not light when the ignition is turned on The control devices are working. The indicator lamp...

Generator Checks
Testing the generator on the bench allows you to determine the generator's serviceability and whether its characteristics correspond to the nominal ones. The brushes of the tested...

Removal and installation the generator
Apply the parking brake to the vehicle, remove the spare wheel and disconnect the wires from the negative terminal of the battery and from terminals 30 and 61 of the generator....

Disassembly and assembly of the generator
Disconnect the wires from the "B" plug of the voltage regulator. Disconnect the wires of the regulator and the capacitor from the "30" terminal of the generator and unscrew the...

Features of the starter device
The starter type (model) 39.3708 is a DC electric motor with mixed excitation, with an electromagnetic two-winding traction relay and with a roller freewheel clutch. In building...

Possible starter malfunctions
Possible starter malfunctions, their causes and solutions. When the starter is turned on, the anchor does not rotate (the traction relay does not work) When the starter is turned...

Checking the starter on the stand
If there are any doubts about the efficiency of the starter, it is necessary to check it on the stand. The stand must have a socket for installing the starter with a bushing for...

Starter repair
Removal and installation The car is braked with the parking brake, the wire is disconnected from the negative terminal of the battery and the spare wheel is removed. The bolt and...

Checking the technical condition of starter parts
Anchor Check with a megohmmeter or a lamp powered by 220 V to see if there is a short circuit between the armature winding and the housing. Voltage is supplied through the lamp to...

Features of the ignition system
The ignition system is contactless. It consists of a sensor 5 (figure 151) moment of spark formation, switch 4, ignition coil 6, spark plugs 7, switch 1 with ignition relay 2 and...

Possible malfunctions of the ignition system
Possible malfunctions of the ignition system, their causes and methods of elimination. The engine does not start Engine runs rough or stalls at idle The engine runs unevenly and...

Checking the ignition system elements on a car
Caution: Since the vehicles described in this book use a high-energy ignition system, do not disconnect the high-tension wires or check the ignition circuits for spark while the...

Testing ignition system elements on a stand
Spark Timing Sensor When taking the characteristics of automatic ignition advance, the spark timing sensor is installed on a stand for testing electrical devices and connected to...

Removal and installation, disassembly and assembly of ignition system elements
To remove the spark timing sensor, brake the car with the parking brake, remove the spare wheel and disconnect the wire from the negative terminal of the battery. Disconnect the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Engine electrics VAZ-2110 (1995-2007)
➠ Electrical equipment: Engine electrics VAZ-21051 (1979-2010)
➠ Electrical equipment: Engine electrics VAZ-2109 (1984-1997)
➠ Power unit: Engine repair VAZ-21011 (1974-1983)
➠ Power unit: Engine repair VAZ-2107 (1982-2012)

Share with friends: