Power window drive
1 - roller mounting bracket; 2 - pressure plate for clamping the cable; 3 – sliding glass clip; 4 - upper roller; 5 – the mechanism of a window regulator; 6 - gasket; 7 - socket; 8 - retaining spring; 9 – the handle of a drive of the mechanism of a window regulator; 10 - tension roller; 11 - cable
Assemble the door in the reverse order of disassembly.
1. Putting the cable 11 on the rollers and fixing the mechanism 5 of the power window, make sure that the coils of the cable on the drum do not overlap; preliminarily tightening the roller nut 10, adjust the tension of the cable by moving the roller and finally tighten the nut
2. To properly fix the sliding glass, install it on the rubber buffer, rotate the window lifter handle shaft to the position corresponding to the lower position of the glass, and then fix the cable on the holder 3 of the glass with the pressure plate 2; check the smooth movement of the glass.
3. With the window fully raised, the power window handle must be set at an angle of 45°from the vertical axis to the front. Before installing the upholstery, check the condition of the plastic spring holders.