Ignition system — general information Scheme of the ignition system 1 - generator; 2 - ignition switch; 3 - ignition distributor; 4 - breaker cam; 5 - spark plugs; 6 - ignition coil; 7 - battery Ignition distributor...
Setting the ignition timing The location of the marks for setting the ignition 1 - mark w.m.t. on the crankshaft pulley; 2 – a label of an advancing of ignition on 10°; 3 – a label of an advancing of...
Ignition distributor — check Preliminary check 1. Before installing the ignition distributor on the stand, check the condition of the breaker contacts (whether the lever with a moving contact sticks on the...
Ignition coil — check To check the health of the ignition coil, the following checks must be made. The ohmic resistance of the primary winding at 20°C should be 3.07–3.5 Ohm, and the secondary winding...
Spark plugs — check If interruptions in ignition are noticed, especially in one or more cylinders, it is necessary to check the condition of the candles. Preliminary check 1. Before testing spark...
Ignition switch — check Ignition switch 1 - locking rod; 2 – the case of the ignition switch; 3 - roller; 4 - contact disk; 5 - contact sleeve; 6 - block; a - wide protrusion of the contact part At the...
Checking elements for suppression of radio interference The radio interference suppression elements include high voltage wires with a distributed resistance of 2000±200 Ohm / m and an interference suppression resistor in the ignition...