Electrical equipment and appliances VAZ-2101 Zhiguli

All articles about the device and repair of electrical equipment and appliances of the VAZ-2101 Zhiguli car.

Wires, fuses and electrical equipment diagram
The electrical equipment is made according to a single-wire scheme: the negative terminals of the current sources and the second terminals of the electricity consumers are...

The device and operation of lighting and light signaling
Headlights On cars 2101 and 2102, as well as on 21011 produced before 1980, the headlights are turned on by switch 34 ( see fig. 150 ), located on the steering column, when the...

Headlight adjustment
The direction of the light beams of the headlights should be such that the road in front of the car is well lit, and oncoming drivers are not blinded when the low beam is turned...

Replacing headlight bulbs
To replace the headlight bulbs, unscrew screw 2 ( see fig. 168 ) fastenings of facing rim 1 and remove it, disengaging it from engagement with bracket 6. Loosen screws 5 fastening...

Removal the turn signal and headlight switch
The switch is secured with a clamp to the steering shaft bracket. The switch is removed in the following order. Remove the steering wheel, then the two halves of the steering...

Possible malfunctions of lighting and light signaling
Possible malfunctions of lighting and light signaling are listed in Table 29.

The structure and operation of the windshield wiper
The windshield wiper connection diagram is shown in Fig. 170. The windshield wiper is switched on by switch 2, located either on the instrument panel (on VAZ-2101, VAZ-2102 and...

Possible malfunctions of the windshield wiper
Possible windshield wiper malfunctions, their causes and troubleshooting methods are given in Table 30.

Windshield wiper repair
Windscreen wiper repair consists mainly of straightening deformed rods and levers of the lever system or replacing them with new ones. It is recommended to replace a faulty...

Heater electric motor
The heater fan is driven by a ME255 direct current electric motor with excitation from permanent magnets. Its design is unified with the windshield wiper electric motor. The...

Sound signals
Two sound signals are installed on cars; one (C305) high with a pipe (C304) low tone. The sound signals are located in the engine compartment and are attached to a bracket...

Nomenclature and characteristics of control and measuring instruments
All control and measuring instruments and control lamps are located in the instrument cluster installed on the instrument panel. The KP191 instrument cluster combines a fuel...

Possible malfunctions of control and measuring instruments
Possible malfunctions of control and measuring instruments, their causes and methods of elimination are given in Table 32.

Checking control and measuring instruments
The accuracy of the devices must be checked on the bench, comparing the readings of the devices with the calibration data given above. Below are methods for determining...

Repair of control and measuring instruments
Repair of the instrument cluster and sensors consists of replacing burnt-out lamps and faulty devices. Removal the instrument cluster To remove the instrument cluster, you need to...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Equipment and devices VAZ-2121 (1977-1994)
➠ Electrical equipment: Equipment and devices VAZ-2109 (1984-1997)
➠ Electrical equipment: Equipment and devices VAZ-2107 (1982-2012)
➠ Electrical equipment: Equipment and devices VAZ-1111 (1988-1996)
➠ Electrical equipment: Equipment and devices VAZ-2114 (2004-2013)

Share with friends: