Repair of suspension and shock absorbers VAZ-21011

Front suspension, wheels, tires — design description
Front suspension 1 – front wheel hub bearings; 2 – hub cap; 3 – adjusting nut; 4 – washer; 5 – steering knuckle journal; 6 – wheel hub; 7 – oil seal; 8 – brake disc; 9 – ball pin...

Determining the condition of the front suspension parts
Checking the condition of the rubber-metal hinge of the front suspension arm 1 – rubber bushing of the hinge; 2 – outer sleeve of the hinge; 3 – suspension arm axle mounting nut;...

Checking and adjusting the front wheel alignment angles
Checking and adjusting the front wheel alignment angles is performed on special stands in accordance with the stand instructions. Attention! Checking the wheel alignment angles is...

Removal and installation the front suspension
1. Place the vehicle on a lift or inspection pit; holding the end of the rod by the flats with the A.57070 key, disconnect the upper end of the shock absorber and remove the front...

Disassembly and assembly of front suspension units
Removal the front wheel hub with puller A.40005/1/B 1 – wheel hub; 2 – puller 1. If the suspension repair requires complete disassembly of its components, it is more convenient to...

Checking the technical condition and repairing the front suspension
Suspension arms The deformation of the upper and lower arms is determined using device A.95716. 1. Install the lower arm so that the mandrel 1 for centering articulates with the...

Replacing rubber-metal hinges of levers on a car
The need to replace rubber-metal hinges is determined by the signs specified in subsection 8.1.2 . The joints can be replaced either directly on the vehicle or on the levers...

Features of the rear suspension device
Rear suspension 1 – spacer sleeve; 2 – rubber bushing; 3 – lower longitudinal bar; 4 – lower spring insulating gasket; 5 – lower spring support cup; 6 – suspension compression...

Removal and installation the rear suspension
Rear suspension parts 1 – lower longitudinal bar; 2 – rubber bushing; 3 – bracket for fastening the lower longitudinal rod to the body; 4 – spacer sleeve; 5 – upper longitudinal...

Checking the technical condition of the rear suspension
Before checking, rinse all parts thoroughly. Protect rubber parts, bushings and protective coatings from solvents when washing. Springs Basic data for checking the rear suspension...

Features of the shock absorber device
Shock absorbers for front and rear suspensions 1 - lower eye; 2 – compression valve body; 3 – compression valve discs; 4 – compression valve throttle disc; 5 – compression valve...

Disassembly and assembly of the shock absorber
1. After external washing, secure the shock absorber in a vice. Attention! To secure the shock absorber and its parts in a vice, use special jaws 67.7824.9513-001. 2. Having...

Checking the technical condition of shock absorber parts
Wash all parts with gasoline or kerosene and dry. Please check carefully that the parts comply with the following requirements: the compression and rebound valve discs, as well as...

Possible malfunctions of the chassis, their causes and methods of elimination
Types of tire wear due to improper wheel alignment I – normal tread wear; II – increased front wheel toe-in (right wheel, rear view); III – negative toe-in of the front wheels...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Suspension and shock absorbers VAZ-2105 (1979-2010)
➠ Chassis: Wheel suspension VAZ-21213 (1994-2006)
➠ Chassis: Suspension and wheels VAZ-2110 (1995-2007)
➠ Chassis: Car suspension VAZ-2109 (1984-1997)

Share with friends: