Pressing out the piston pin (VAZ-21011)

1. The pin must be removed using a press, using the A.60308 mandrel and a support with a cylindrical recess into which the piston is placed. Before pressing out the pin, remove the piston rings.

2. If the removed parts are slightly worn and not damaged, they can be used again. Therefore, when disassembling, mark them so that later you can assemble a group with the same parts.

(Original source is on the resource VazBook)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text was reviewed by the specialist: Grigory Vologodtsev

Share with friends:

VAZ-21011: Engine repair

Features of the design of pistons and connecting rods
Parting plane with cylinder head
Cylinders — Checking the condition
Checking the cylinder block for leaks
General cleaning and inspection of the cylinder block

Cleaning pistons and connecting rods
Selecting a piston for a cylinder
Checking the clearance between the piston and the pin
Checking the clearances between piston grooves and rings
Checking the clearance between the connecting rod bearings and the crankshaft