Remove rear wheels and brake drums. Disconnect the brake hose from the pipeline attached to the bridge, plugging the openings of the hose and pipeline with plugs. Having unscrewed the bolts securing the ends of the cable sheath to the brake shields, disconnect the ends of the cable from the levers of the manual drive of the pads and remove them from the shields.
Disconnect the pressure regulator rod from the axle beam, and the cardan shaft from the gearbox. Install supports under the rear axle and disconnect the suspension hoses and shock absorbers from the axle beam. Remove the rear axle.
Install the rear axle in reverse order. At the same time, tighten the nuts for fastening the rods in accordance with the instructions in section «Rear suspension». After installation, bleed the brake system, adjust the service and parking brakes according to the section «brakes» and fill with TAD-17 oil and the rear axle gearbox.