Contents: Front doors ↓ Rear doors ↓
Front doors
1. Remove the trim from the front doors, lower the glass until it stops against the rubber buffer and unscrew screws 6 (see Fig. Front window drive) pressure plates for fastening the cable.
2. Turn the window lift handle 1 until the bushing (mark) on the front vertical branch of the cable aligns with the middle of the front bracket 8 of the window and tighten the screws of both pressure plates.
3. Check the smoothness of the window lifter operation. If necessary, adjust the smoothness of the operation by tensioning the cable with tension roller 13.
Rear doors
View the original on the internet resource VAZBOOK.ru
1. At the rear doors, remove the trim, lower the glass and loosen the screws 3 of the cable mounting pressure plate 4.
2. Lower the glass until it stops against the rubber buffer 2.
3. Turn the window lift handle to the limit in the direction of glass lowering, and then half a turn in the opposite direction. With the glass and cable in this position, tighten the screws of the 3 pressure plates.
4. Check the smooth operation of the window lift.
5. If necessary, adjust the cable tension using tension roller 5.