Comment. In the lining of the instrument panel next to the switches, control lamps for switching on the corresponding devices are installed (see more details. "Governing bodies").
Removing
1. Disconnect the wire terminal from the negative terminal of the battery (see "Preparing the car for maintenance and repair").
2. Using a Phillips screwdriver with a short blade, unscrew the four screws securing the instrument panel lining (two above and two below).
3. We turn over the lining and disconnect the block from the switch being removed.
4. Remove the switch from the lining of the instrument panel.
Comment. If it is necessary to remove the lining from the instrument panel, mark (with a marker or by making stickers with inscriptions) the procedure for connecting the blocks to the switches and control lamps. This will make assembly easier.
To disconnect the control lamp blocks, you can use pliers with narrow jaws. Don't crush the pads.
Installation
Install the removed switches and instrument panel trim in reverse order.