Basic data for adjustments and control
Clearances in the valve drive mechanism on a cold (18–20°C) engine, mm, for intake/exhaust valves | 0,2±0,05/0,35±0,05 |
Minimum crankshaft speed at idle, min⁻¹ | 820–900 |
Oil pressure in the engine lubrication system at an oil temperature of 85°C and a crankshaft speed of 5600 min⁻¹, not less than, MPa (kgf/cm²) | 0,45 (4,5) (In brackets – for engine mod. 11113) |
Density of coolant Tosol A-40 at 20°C, g/cm³ | 1,078–1,085 |
Temperature of the liquid in the cooling system of a warmed-up engine at an air temperature of 20–30°C, full load and movement at a speed of 80 km/h, no more than,°C | 95 |
Coolant level in the expansion tank on a cold engine | 25–30 mm above the "MIN" mark |
Spark plug electrode gap, mm | 0,7–0,85 |
Initial ignition advance angle before TDC, deg | 1±1 (4±1) (In brackets – for engine mod. 11113) |
Full travel of clutch pedal, mm | 110±5 |
Free travel of the brake pedal with the engine off, mm | 3–5 |
Free play of the steering wheel in the straight-ahead position, no more than, degrees | 5 |
Front wheel alignment for a run-in vehicle under a load of 2200 N (225 kgf), mm | 0±1 |
Front wheel camber for a run-in vehicle under a load of 2200 N (225 kgf), deg | 0°±30' |
The same when measuring between the rim and the vertical, mm | –3...+3 |
Longitudinal tilt of the wheel pivot axis for a run-in vehicle under a load of 2200 N (225 kgf), deg | 2°±30' |
Tire pressure front and rear, MPa (kgf/cm²) | 0,18 (1,8) (In brackets – for engine mod. 11113) |
Minimum permissible thickness of linings for front and rear brake pads, mm | 1,5 |
Fluid level in the brake hydraulic reservoir with the cap installed | to the lower edge of the filler neck |
Maximum slope on dry hard ground on which a fully loaded vehicle is held indefinitely by the parking brake when the lever is moved by 4–5 teeth of the sector, % | 30 |