Location of the oil filter on the engine
Refueling volume of the engine crankcase - 2.5 liters.
The list of oils recommended by the manufacturer is given in application "Fuels and lubricants and operating fluids".
Drain the oil after driving while the engine is still warm. If the engine is cold, start and warm it up to a temperature of approximately 80°C on the coolant temperature gauge. It takes at least 15 minutes for the oil to drain completely.
It is recommended to fill in the oil of the same brand as was in the engine. If you still decide to change the brand of oil, then flush the engine lubrication system with flushing oil or oil of the brand that will be poured into the engine. To do this, after draining the old oil, fill in new oil to the lower mark of the oil level indicator. Start the engine and let it idle for 10 minutes. Drain the oil and only then change the oil filter. Now you can fill in new oil to the required level (top mark on dipstick).
Special wrench for removing the oil filter
2. Carefully (as the oil is hot) unscrew the drain plug on the engine crankcase, after substituting a container under it, and drain the used oil. 3. Unscrew the oil filter with a special wrench. If there is no such key, and the filter cannot be unscrewed by hand, pierce the filter housing with a screwdriver and unscrew the filter using it as a lever. Punch the filter closer to its bottom so as not to damage the fitting on the engine. Screw the drain plug into the engine crankcase.
4. Before installing the oil filter, fill it with new engine oil to approximately half its capacity.
5. Lubricate the O-ring of the new filter with engine oil. Screw the new filter onto the engine fitting by hand.
6. Fill in the required amount of new oil, controlling its level on the pointer. Screw the plug into the head cover.
7. Start the engine and let it idle for a few minutes (the low oil pressure warning lamp should go out 2-3 seconds after the engine is started). Stop the engine, check the oil level and top up if necessary.