The volume of oil in the engine lubrication system is 3.5 liters.
Recommendation. It is better to change the oil on a hot engine to remove it more completely.
Warning. The oil is hot - don't burn your hands!
To get the job done you will need:
- viewing hole or flyover;
- oil filter puller;
- wide capacity of at least 4 liters.
Engine oil change sequence
1. We prepare the car for work (see item 2b "Preparing the car for maintenance and repair").
2. Install the container under the engine.
3. Unscrew the oil filler cap.
4. Using a 17 mm wrench, unscrew the oil drain plug on the engine crankcase pan.
5. Drain the oil from the engine.
6. After waiting for the oil to completely drain from the engine crankcase, we wrap the drain plug.
7. Loosen the oil filter with a puller.
Unscrew the oil filter by hand.
8. We wipe the mating surface of the oil filter on the cylinder block with a clean rag.
Recommendation. Before installing a new oil filter, fill it with oil 2/3 of the volume.
9. We apply clean engine oil to the rubber o-ring of the oil filter and wrap it in place.
10. Tighten the oil filter only by hand.
11. Pour oil into the engine through a funnel, controlling its level on the dipstick ("Checking the engine oil level").