Removing
1. Remove the rear door trim.
2. Remove the power window.
Note. When carrying out the following work, do not use a screwdriver as a lever.
4. We slip a slotted screwdriver with a wide blade under the decorative trim (the pad is attached to one spring clip located on its inner side in the center). Turning the screwdriver around its axis, remove the trim from the door.
5. Remove the upper rubber glass seal.
6. Using two slotted screwdrivers, remove the inner lower glass seal, starting from the rear end. Using a thin-blade screwdriver, we press the bottom edge of the seal and disengage it from the door panel. At the same time, with a screwdriver with a wide blade, lift the seal, preventing it from catching.
7. We remove the glass through the opening between the outer and inner door panels.
Note. If it is necessary to completely disassemble the door, then, by slightly pressing with one hand on the outer seal, with the other hand, we remove the lower edge of the seal from engagement with the inner panel of the door and remove the seal.
Installation
We install the glass and all previously removed parts on the car in reverse order.