Note. Removal and installation of a covering are shown on an example of the right back door. All equipment of the left rear door can be removed and installed in the same sequence.
The doors of cars of the last years of production are equipped with a central lock with an electric drive.
The rear door lock has a blocking of opening from the passenger compartment, the lock lever is located on the rear end surface of the door. The door locks can be blocked when transporting children in the rear seat.
Removing
1. We prepare the car for repair work.
2. Using a Phillips screwdriver, unscrew the door lock button.
3. From the back of the window handle (1) insert the blade of a thin slotted screwdriver between the socket (3) and handle lining (2). We press the facing of the handle from the socket, releasing the latch (ledge) located on the inside of the handle facing. In this position...
...we move the lining along the axis of the handle and remove it.
4. Remove the power window handle and socket from the power window drive mechanism shaft.
5. Remove the armrest handle.
6. Using a Phillips screwdriver, unscrew the three screws securing the bottom trim of the door trim.
7. Remove the door trim trim.
8. Slotted screwdriver with a wide blade (laying under it a fabric folded in several layers) pry the trim off the door. At the same time, we remove eight holders for fastening the skin from the door holes.
9. Slightly lift the trim and remove it from the door.
Installation
We install the door trim and all previously removed parts on the car in reverse order.
Before installing the skin, we check the fastening holders - we replace deformed or damaged holders.
When installing the skin on the door, we combine the skin holders with the holes in the door panel and with light blows of the base of the palm we sink the holders into the holes.