Removal
1. Prepare the car for repair work.
2. Using a slotted screwdriver, pry up and remove the four fastening clips of the trunk lid lock trim.
3. Remove the lock cover.
4. Disconnect the motor-reducer rod from the lock.
5. While holding the nut from turning with a 7 mm wrench, use a slotted screwdriver to unscrew the rod mounting screw.
6. Using an 8 mm socket wrench, unscrew the bolt securing the trunk lock cylinder.
7. Remove the lock from the trunk lid from the outside.
8. Disconnect the rod from the lock and remove the rubber sealing gasket.
9. Using a 10 mm socket wrench, unscrew the three nuts securing the lid lock.
10. Remove the internal lock from the trunk lid.
11. If necessary, use a 10 mm wrench to unscrew the two bolts securing the lock retainer and remove it from the rear panel.
Installation
We install the lock and all previously removed parts on the car in the reverse order.
Adjustment
Having loosened the bolts that secure the lock retainer, we move it from side to side and find a position in which the middle of the retainer loop fits exactly into the slot in the lock, after which we tighten the bolts that secure the retainer.
We adjust the tightness of the trunk lid closing by moving the lock within its mounting holes.