Contents: Removal ↓ Installation ↓
Note: The work is shown with partial disassembly of the door. If necessary, the door can be removed after dismantling all its elements (see relevant sections).
Tip: When replacing a door, install the new door on the vehicle before painting and assembling it to ensure it does not require any straightening.
An assistant will be needed to complete the job.
Removal
1. Remove the door trim (see "Front door trim - removal and installation").
2. Remove the plastic film from the door.
3. Remove the wire terminal from the negative terminal of the battery (see "Preparing the car for maintenance and repair").
4. Disconnect the wiring block of the window lifter motor-reducer (see "Front door window lifter - removal and installation").
5. Disconnect the wiring block of the central lock switch (see "Front door lock - removal, installation and adjustment").
6. Disconnect the door stop from the rack (see above, "Front door opening limiter - removal and installation").
Warning: To avoid deformation of the door, do not open it wide after detaching the door stop.
7. Disconnect the corrugated cover of the wiring harness from the door.
8. We remove the wires together with the pads through the hole in the end of the door.
Warning: The door must be supported by an assistant when performing the following operation.
9. With a socket wrench by 13 mm unscrew the two door mounting bolts (one on each loop) and remove the door from the car.
The original is on the portal www.VAZbook.ru
Installation
We install the door in reverse order.