- key "10"
- screwdriver
If the parking brake lever does not lock in the selected position, first check the pawl spring. If the spring is good, replace the lever.
The vehicle is equipped with a non-separable parking brake lever 1. If the lever is damaged, it must be replaced as an assembly. Rod 2 must be replaced if the thread is damaged.
1. Remove the equalizer from the rod (see subsection 7.4.1.).
2. From inside the cabin, unscrew the two mounting bolts on one side of the lever.
(The text is copied from the online resource: vazbook.ru)
3. Please note: There are spring washers under the bolt heads.
4. Move the carpet to access the two control arm mounting bolts on the other side and remove them.
5. Remove the lever from the vehicle.
6. Remove the retaining ring from the tie rod pin.
7. Remove your finger.
8. Remove the rod from the lever.
9. Replace a torn or loosened traction cover (from below the car).
10. Assemble and install the parking brake lever in the reverse order of removal. After installing the lever, adjust the parking brake.
11. To replace the pawl spring, unscrew the button from the lever (without removing the lever from the car) and...
12....remove the spring. Install a new spring and screw the button back in.