It is recommended to use a special key to tighten the brake pipe mounting nuts.
The replacement is shown using the example of a tube from the pressure regulator to the wheel cylinder of the rear left wheel.
Attention! To prevent sudden failure of the brake system, regularly inspect the brake pipes. They should not be damaged or heavily corroded.
Attention! Weakening or breakage of pipeline holders leads to vibration and, as a consequence, breakage of pipelines.
1. Unscrew the tip of the brake pipe from the pressure regulator to the rear left wheel.
2. Disconnect the tube from the pressure regulator. Plug the hole in the pressure regulator.
3. Using a second wrench, hold the rear wheel brake hose tip by the hexagon and unscrew the tube tip.
4. Disconnect the hose from the tube.
[The source is on the website: VAZBOOK]
5. Remove the spring clip from the tube. Replace the broken clip.
6. Bend back the two mounting brackets on the body.
7. Remove the tube from the five plastic holders. Install a new tube in the reverse order of removal and bleed the brake hydraulic system.