Disconnect the wire from the "–" terminal of the battery.
The washer pump is a non-separable structure and must be replaced in case of any defects.
Attention! Do not turn on the pump electric motor if the pump intake is not immersed in liquid, otherwise the electric motor may burn out (a short-term switch-on for 1–2 s is allowed to check the operation of the electric motor).
1. Disconnect the two wire connectors from the pump motor terminals.
2. Remove the washer reservoir from the bracket on the body.
3. Disconnect the hose from the pump fitting and drain the liquid from the tank.
4. Using a screwdriver, push the pump intake out of the rubber sealing sleeve and...
5....remove the pump from the tank.
6. Replace a cracked or loose sealing sleeve.
7. Install the new pump in the reverse order of removal. Note that the connector with two black wires is connected to the "-" terminal, and the connector with one pink wire is connected to the "+" terminal of the pump's electric motor.