Windshield washer jet
1 - atomizer; 2 - screw; 3 - bushing; 4 - jet body with fitting
If the jets are clogged, remove and disassemble them.
1. On the side of the air intake box of the body, slightly squeeze the plastic sleeve 3, and by hooking it from above with a screwdriver and overcoming resistance, remove the jet assembly with the sleeve.
2. Remove screw 2, thoroughly clean all parts and blow compressed air through housing cavity 4 and nozzle 1.
3. After assembly, insert the sleeve 3 into the opening of the body. Then sharply insert the jet into the sleeve 3 so that the housing 4 fits into the flanges of the sleeve with a groove. Connect the tube to the jet.
4. Check jet action.
5. Adjust the direction of the liquid jet by turning the housing 4 in the sleeve 3 and turning the atomizer 1 while loosening the screw 2. After the adjustment is completed, tighten the screw 2.