To replace the bulbs in the headlight, turn the casing counterclockwise until it stops and remove it. Remove the block 2 (Fig. 44), remove the ends of the spring retainer 4 from the grooves, turn the retainer to the lower position and remove the socket 3 with the headlight bulb assembly.
To replace the parking light bulb, remove socket 1 together with the bulb. To replace the turn signal bulb, turn socket 5 counterclockwise and remove it from the socket.
To replace the lamp in the rear light, from the luggage compartment side, unscrew the screws 1 (Fig. 45) securing the protective cover 2 and remove it, press the retainer 4 securing the board 3 together with the lamps 5 and remove it. Remove the lamp from the socket by lightly pressing on it and turning it counterclockwise.
To replace a burnt-out lamp in the rear light of a station wagon, follow these steps: unscrew the fasteners from screws 1 (Fig. 46) from the inside of the luggage compartment, disengage spring clips 3 from the body, remove the light from the body, disconnect the terminal block from terminals 5, then squeeze the clamps 2 and remove the printed circuit board 4 complete with lamps.
To replace the bulb in the license plate light, unscrew the screws 1 (Fig. 47) securing the light, remove it from the socket and remove the diffuser 2.
To replace the bulb in the interior light shades located on the central pillars and held in the recesses by spring stops, carefully pull the shade towards you and replace the bulb (fig. 33).
Replace the burnt-out bulb in the side turn signal (Fig. 48) after removing the socket with the bulb from the inside of the wing.
Replacing a burnt-out bulb in the instrument panel (fig. 19) perform after removing the instrument panel from the panel, for which remove the plugs 9 and unscrew the screws securing the panel.
To replace the bulb in the instrument cluster (fig. 21) remove plug 31 (fig. 20), unscrew the screw securing the shield, remove the handles from the heating control levers, unscrew the speedometer cable by pushing out the right edge of the shield, then pull out the shield together with the instrument cluster by moving it to the right towards you.
(The original is posted on Internet resource: www.VAZbook.ru)
To access the lamp in the hazard warning switch, unscrew the switch button.