Car gearbox VAZ-21214

All articles on the device and repair of mechanical gearbox units of VAZ-21214 Niva cars and their modifications.

Elements and features of the gearbox device
1 – primary shaft; 2 – primary shaft seal; 3 – clutch housing; 4 – spring washer; 5 – breather; 6 – secondary shaft needle bearing; 7 – toothed ring of the 4th gear synchronizer;...

Gearbox oil change
Attention! We carry out the work on an inspection pit or lift. Before changing the oil, it is necessary to warm it up by driving the car for at least 10 km. Using a 12 mm Allen...

Replacing the primary shaft seal
Attention! We carry out the work on an inspection pit or lift. Remove the gearbox (see Removal the gearbox ). Using a 13 mm socket head, unscrew one nut at the bottom of the...

Replacing the secondary shaft seal
Attention! We carry out the work on an inspection pit or lift. Remove the transfer case with the intermediate shaft (see Removal the transfer case ). Remove the rubber centering...

Removal the gearbox
Attention! We carry out the work on an inspection pit or lift. Disconnect the negative cable from the battery. Remove the transfer case with the intermediate shaft (see Removal...

Removal the front bearing of the gearbox primary shaft
Attention! We carry out the work on an inspection pit or lift. We remove the bearing for replacement. Remove the flywheel (see Replacing the rear crankshaft oil seal ). To remove...

Disassembly and assembly of the gearbox
We drain the oil from the gearbox, remove the fork and the clutch release bearing (see relevant sections). We dismantle the flange of the elastic coupling from the nose of the...

Elements and description of the intermediate shaft
Intermediate shaft: 1 – elastic coupling; 2 – elastic coupling mounting bolt; 3 – elastic coupling flange; 4 – protective cover; 5 – casing; 6 – separator; 7 - ball; 8 – stud for...

Removal the intermediate shaft
We remove the transfer case assembly with the intermediate shaft (see Removal the transfer case ). Holding the shaft from turning with a screwdriver, use a 13 mm wrench to unscrew...

Disassembling the intermediate shaft
We disassemble the intermediate shaft to replace the elastic (rubber) coupling or constant velocity joint. We mark the location of the coupling relative to the flange,… …as well...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Transmission: Car gearbox VAZ-2110 (1995-2007)
➠ Transmission: Car gearbox VAZ-21011 (1974-1983)
➠ Transmission: Car gearbox VAZ-2105 (1979-2010)
➠ Transmission: Car gearbox VAZ-2106 (1976-2006)
➠ Transmission: Car gearbox VAZ-2107 (1982-2012)

Share with friends: