Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for repair work.
2. Remove the battery.
3. Remove the decorative plastic cap of the left wiper arm mounting nut.
4. Using a 10 mm open-end wrench, unscrew the lever mounting nut.
5. Remove the windshield wiper arm from the shaft and mark it with a marker.
Helpful advice: If the lever fits tightly on the shaft, then we screw the nut onto the shaft thread and press the lever using sliding pliers.
6. Remove the right windshield wiper arm in the same way.
7. Using a thin slotted screwdriver, remove the four decorative plugs covering the screws of the upper air intake grille mount.
8. Using a Phillips screwdriver, unscrew the four screws that secure the upper air intake grille.
9. Remove the engine compartment partition seal.
10. Using a Phillips screwdriver, unscrew the six screws securing the right and left parts of the engine compartment trim to the air intake grille.
11. Using a 10 mm socket wrench, unscrew the two nuts securing the right and left air intake grille to the body brackets.
12. Disconnect the hose from the windshield washer pump.
The original is posted on Internet resource [VAZBOOK]
13. Pulling the washer hose out of the engine compartment bulkhead, remove the air intake grille.
Installation
We install the air intake grille and all the removed parts on the car in the reverse order. At the same time, we put the windshield wiper arms on the shafts in accordance with the marks.