Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for repair work.
2. From the inside of the cover, use a Phillips screwdriver to unscrew the screw securing the right spoiler.
3. Similarly, unscrew the screw securing the spoiler on the left side of the cover.
4. Using a Phillips screwdriver, unscrew the four screws securing the spoiler (two on top and two at the back).
5. Having lifted the front part of the spoiler, we remove it from the car.
Note: The front part of the spoiler is secured to the cover with adhesive tape (1). If necessary, the tape can be carefully trimmed with a knife. The rear part of the spoiler is held in place by three tabs (2) that engage with the spoiler base.
6. Disconnect the additional brake light wire connectors.
7. Disconnect the tube from the windshield washer nozzle.
Helpful Hint: To make it easier to pick up the handset in cold weather, you can warm it up with a hair dryer or hot water.
8. Using a Phillips screwdriver, unscrew the four screws securing the spoiler base.
9. Remove the spoiler base from the trunk lid.
Installation
We install the spoiler and all previously removed parts on the car in the reverse order. In this case, we remove the damaged adhesive tape and stick a new one.
Helpful Hint: You can apply sealant to damaged areas of the tape.