Contents: Removal ↓ Installation ↓
Note: In the instrument panel trim, next to the switches, there are control lamps for the corresponding devices.
Removal
1. Disconnect the wire terminal from the negative terminal of the battery.
2. Using a Phillips screwdriver with a short blade, unscrew the four screws securing the instrument panel trim (two on top and two on the bottom).
3. Turn the trim over and disconnect the connector from the switch being removed.
4. Remove the switch from the instrument panel trim.
Note: If you need to remove the instrument panel trim, mark (with a marker or by making stickers with inscriptions) the order of connecting the connectors to the switches and control lamps. This will make it easier to assemble the instrument panel later.
To disconnect the connectors of the control lamps, you can use pliers with narrow jaws. Do not crush the connectors when doing this.
5. Defective switches must be replaced.
Installation
We install the removed switches and instrument panel trim in the reverse order.