Contents: Removal ↓ Installation ↓
Removal
1. Remove the pressure and driven clutch discs (see "Clutch - replacement").
2. Using any available method, mark the position of the flywheel on the shaft.
3. With a socket wrench by 17 mm we unscrew the six flywheel mounting bolts, holding it from turning with a mounting blade or screwdriver, resting it against the protrusion of the cylinder block.
[The text is copied from the online portal: VAZbook.ru]
4. Remove the washer.
5. Remove the flywheel from the crankshaft.
6. If necessary, remove the upper clutch housing cover from the guide bushings.
Installation
We install the flywheel in the reverse order in accordance with the mark made during disassembly. Before tightening the flywheel mounting bolts, apply thread lock to their threaded part.
Note. The flywheel must be installed on the crankshaft in only one position. For this purpose, there is a mark made by drilling on the outer side of the flywheel. When installing the flywheel on the crankshaft, the mark must be located opposite the connecting rod journal of the fourth cylinder.
