- viewing hole or flyover;
- height-adjustable stand (screw or hydraulic jack).
Removing
1. Remove the alternator belt (see "Alternator drive belt - replacement").
2. Install the height-adjustable stand (jack) under the engine and raise it a little, unloading the right support.
3. socket wrench by 17 mm unscrew the upper nut of the pillow bolt.
4. socket wrench by 15 mm unscrew the cushion bolt.
5. We take out the bolt together with the lower limiter.
6. Having slightly raised the engine on the jack, we take out the curly nut and the upper limiter from under the engine bracket.
7. socket wrench by 13 mm unscrew the two bolts securing the pillow to the body bracket.
8. Remove the pillow.
Installation
We install the right support in the reverse order, while the curly nut of the support bolt must be installed on the upper limiter with the projections up and enter the groove of the bracket.