- height-adjustable stand (screw or hydraulic jack);
- viewing hole or flyover.
Removing
1. Install the height-adjustable stand (jack) under the gearbox housing.
2. socket wrench by 17 mm unscrew the two nuts securing the support to the body.
3. On the stand, lower the back of the power unit by 10-15 mm.
4. Two keys by 19 mm unscrew the nuts of the bolts securing the support bracket to the gearbox housing and take out the bolts and remove the support.
5. If it is necessary to replace the support pad, unscrew it with a key by 19 mm bracket bolt and remove the pillow and thrust washers from the bracket.
Installation
We assemble and install the rear support in reverse order.