Contents: Removal ↓ Installation ↓
To complete the work you will need:
- height adjustable stop (screw or hydraulic jack);
- inspection pit or overpass.
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the engine splash guard (see "Engine Mudguard - Removal and Installation").
3. Place a height-adjustable support (jack) under the gearbox and lift the gearbox slightly, relieving the left support.
4. With a socket wrench by 15 mm with an extension, unscrew the support stud nut and remove the upper support limiter. Lower the gearbox slightly on the jack and remove the cushion stud from below.
5. With a socket wrench by 13 mm we unscrew the two bolts securing the support cushion to the body bracket.
6. Slightly moving the cushion towards the engine, remove it from the bracket.
7. Remove the lower support stop.
Installation
We install the new support in the reverse order.
To prevent the stud from turning, its protrusions must enter the oval hole in the gearbox housing bracket.
