- replacement head "for 24"
- extension
- crank
- keys "10", "13"
- screwdriver
- mandrels for pressing out and pressing in steering shaft bearings
- hammer
Disconnect the wire from the "-" terminal of the battery.
Remove the steering wheel (see subsection 6.1.), remove the instrument cluster from the instrument panel (see subsection 8.6.1.), remove the intermediate steering shaft (see subsection 6.2.).
The steering column uses two ball bearings 2108-3401120 (the same as on front-wheel drive VAZ models). The GPZ marking is applied to the side of the outer ring of the bearing. Bearing number (according to GPZ) is 1000805.
1. Place the bracket assembly with the steering column shaft in a vice and...
2....using a soft metal drift, tap the steering column shaft out of the bracket.
View the original on the internet resource: www.vazbook.ru
3. Remove the shaft from the bracket.
4. Use a screwdriver to remove the bearing from the steering column shaft.
5. Insert the shaft into the bracket and press out the second bearing using a hammer through a soft metal mandrel.
6. Install the new bearing into the steering column shaft bracket with the narrow flange of the bearing sleeve facing outward.
7. Press the bearing in until it stops using a mandrel. It should rest only on the outer ring of the bearing.
8. Insert the steering column shaft into the bracket.
9. Install the second bearing into the shaft bracket (see operation 6) and...
10....press the bearing in using a drift. It should rest only on the outer ring of the bearing. Install the steering column on the car in the reverse order of removal.