Section of the pendulum arm bracket
1 – pendulum lever; 2 – bracket body; 3 – washer; 4 – adjusting nut; 5 – cotter pin; 6 – upper washer; 7 – seal; 8 – bushing; 9 – lever axis; 10 – lower washer; 11 – self-locking nut
1. To remove the pendulum arm bracket, separate the pendulum arm from the ball pins of the middle and right side rods by first removing the cotter pins and unscrewing the nuts and using puller A.47052 to remove the ball pins from the arm sockets.
2. Then unscrew the bolts securing the bracket to the side member and remove the bracket.
3. Secure the bracket in a vice, remove the cotter pin and unscrew the nut 4 (see fig. Section of pendulum arm bracket).
4. Then remove washers 3 and 6 and pendulum arm 1 assembled with axle 9, washer 10 and self-locking nut 11.
5. Remove seals 7 and press out bushings 8.
The text is copied from the online resource VazBook