Removing the ball pins of the steering trapezoid rods
1 - wrench; 2 - puller A.47052; 3 - ball joint; 4 – the right lever of a rotary fist
1. Loosen and remove the nuts that secure the side link ball pins to the swing arms.
2. Puller A.47052 remove the ball pins from the conical sockets on the levers.
3. Loosen and unscrew the nuts securing the ball pins of the middle and side rods to the bipod and to the pendulum arm. Using puller A.47035, remove the pins from the corresponding sockets on the levers and remove the rods.
4. Installation of drafts of a steering make in an order, the return to removal.
5. Tighten all ball stud nuts with a torque wrench followed by cotter pins. If the cutout of the nut does not line up with the hole for the cotter pin, then tighten the nut by an angle less than 60°to ensure the cotter pin.
6. After installing the tie rods, adjust the toe of the front wheels.