Cleaning the lubrication system channels (VAZ-21011)

1. To clean, remove the channel plugs. Then run through the plug sockets with the countersink A.94016/10, put on the spindle A.94016, thoroughly wash the channels with gasoline and blow with compressed air.

2. Apply UG-6 sealant to the surfaces of the plug sockets. Press in new plugs using A.86010 mandrel and, for greater reliability, calk each plug at 3 points with a center punch.

The original can be seen on the website (www.VazBook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text was reviewed by the specialist: Grigory Vologodtsev

Share with friends:

VAZ-21011: Engine repair

Features of the crankshaft and flywheel
Parallelism of the axes of the lower head of the connecting rod and the piston pin
Checking the pin pressing
Assembly of the connecting rod and piston group
Piston mass control

Main and connecting rod journals
Main bearing shells
Flywheel — Checking the condition
Checking the axial clearance of the crankshaft
Features of the cylinder head and valves