Tip: For ease of operation, you can remove the windshield washer reservoir (see "Windscreen washer reservoir - removal and installation")
2. With a socket wrench by 10 mm, put on the nut of the rear timing belt cover, we hold the camshaft pulley from turning, using a key by 17 mm unscrew the pulley mounting bolt.
3. Remove the pulley from the shaft.
4. Remove the key from the groove.
Warning: When performing the following operation, be careful not to scratch the working surface of the shaft.
5. Pry and remove the seal from its seat using a hook, screwdriver or pliers with curved jaws.
6. Lubricate the working surface of the new seal with clean engine oil and carefully place the seal on the shaft.
7. Press in the new seal using the tool head by 30 mm as a mandrel.
8. Install the timing belt in place (see "Timing Belt - Replacement").
9. Further assembly is carried out in the reverse order of disassembly. After that, adjust the tension of the generator drive belt (see "Generator Drive Belt - Checking Condition and Adjusting Tension").