- keys "on 10" And "at 13"
- screwdriver
If a leak is found from the master brake cylinder, remove it from the vehicle and repair the cylinder.
Attention! Repair of the master cylinder often does not lead to the desired results, so it is recommended to replace it as an assembly.
1. Loosen the clamps and...
2.... Disconnect two hoses from unions of the main cylinder. Plug holes in hoses.
3. Unscrew the tip of the brake pipe and...
4.... Disconnect the tube from the master cylinder. Plug the hole in the tube.
5. Disconnect the other two tubes from the master cylinder in the same way.
6. Loosen the two master cylinder nuts.
7. Please note: spring washers are installed under the nuts.
8. Remove the master cylinder from the studs. Install the master cylinder in the reverse order of removal. Bleed the hydraulic brakes.