Attention! We carry out work on a viewing ditch or a lift.
Disconnect the brake pipe from the rear wheel cylinder (see Replacing the rear wheel cylinder).
Using a screwdriver, we bend the clamping bracket holding the brake pipe on the rear axle beam.
The right brake pipe is held by two clamping brackets, the left one by one.
ring wrench «on 10» unscrew the nut securing the tee to the rear axle beam.
Raising the tee, put on a special key «on 10» on five faces of the brake pipe fitting and unscrew it.
If it is difficult to unscrew, we put on the ring wrench «on 10» (better hex) on the free end of the brake pipe from the side of the wheel cylinder..
... and, holding the tee with sliding pliers, unscrew the fitting of the brake pipe.
Remove the right brake pipe.
Remove the left brake pipe in the same way.
To replace the tee, disconnect the fittings of the brake pipes and the tip of the brake hose from it (see Removing the rear brake hose).
Having unscrewed the nut securing the tee to the rear axle beam,..
... remove the tee from the stud.
Install the tee and brake pipes in reverse order.
We pump the brake system. (see Bleeding the brakes).