The misalignment of the holes in the paws of the generator covers should be no more than 0.4 mm. Therefore, during assembly, it is necessary to insert a special gauge into these holes. It is a stepped cylindrical mandrel with a diameter of 12 mm on one side and 22 mm on the other.
1. The generator is assembled in the reverse order of disassembly.
2. When assembling the generator 37.3701 of release before 1996. (with a collapsible assembly regulator-brush holder) in order to avoid breakage of the brushes, before installing the regulator with the brush holder in place, it is necessary not to fully insert the brush holder into the regulator, but only partially push it in and insert it into the generator in this form.
3. The convex side of the pulley spring washer must be in contact with the nut. Tighten the pulley nut to a torque of 38.4–88 N·m (3.9–9.0 kgf·m).
4. After installing the brush holder in place in the generator cover, lightly press the regulator to slide it into the generator.