1. Tightening torques for threaded connections are specified in application. Finally tighten the threaded fasteners of the powertrain mounts and front suspension components after the vehicle is placed on the floor (before tightening, rock the front of the car two or three times).
2. When connecting the front wheel drives to the gearbox, replace the retaining rings on the splined tails of the inner joints. Do not install used retaining rings - this may lead to the front wheel drives becoming disconnected from the gearbox while driving.
3. Fill coolant, oil in the engine crankcase, oil in the gearbox
. 4. After installing the engine on the vehicle, adjust the throttle drive, clutch drive, and front wheel alignment angles.
5. Start the engine and check for fuel, oil and coolant leaks. Check the oil pressure. Listen to the engine, it should run smoothly, without any extraneous noise or knocking. Check the operation of the indicator lights in the instrument cluster.
The source is on the website vazbook.ru