1. Remove the wire from the "-" terminal of the battery.
2. Remove the safety clip…
3. …turn the throttle valve to the stop. Remove the end of the accelerator drive cable from the throttle valve drive sector.
4. Loosen the adjusting nuts of the accelerator cable housing.
5. Remove the safety cap from the cable end, unscrew the lock nut…
6. …and disconnect the accelerator drive cable from the bracket.
7. Remove the screw securing the fuel pipe pressure plate to the bracket…
8. …and remove the plate.
9. Unscrew the two nuts securing the fuel pipe bracket to the receiver…
10. …and remove the bracket.
11. Disconnect the wiring harness connectors from the throttle position sensor and idle air control valve.
12. Unscrew the nut securing the bracket to the receiver.
13. Loosen the clamp and disconnect the crankcase ventilation hose from the fitting on the throttle assembly.
14. Loosen the clamp and disconnect the brake booster and fuel pressure regulator vacuum hoses from the fittings on the receiver.
15. Unscrew the nuts securing the receiver to the intake manifold…
16. …and remove the receiver from the studs.
17. Remove the receiver sealing gasket.
Note: When installing the receiver, replace the sealing gasket.
18. Disconnect the engine wiring harness connector from the injector wiring harness and remove the fuel rail (see "Checking and replacing injectors").
The article is taken from the website (VazBook.ru)
19. Loosen the nuts securing the bracket to the intake manifold and manifold heat shield…
20. …remove the bracket,
21. Remove the two screws securing the heat shield to the intake manifold and remove the heat shield.
22. Unscrew the two nuts and remove the eye.
23. Disconnect the inlet pipe from the exhaust manifold (see "Replacing the inlet pipe").
24. Loosen the nuts and remove the intake and exhaust manifolds (see "Cylinder head (repair)").
25. Install new sealing gaskets for the intake and exhaust manifolds, muffler inlet pipe, and receiver.
26. Install the removed parts in the reverse order of removal.