Contents: Removal ↓ Installation ↓
To complete the work you will need inspection pit or overpass.
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the receiver (see "Engine receiver 2111 (1.5i 8v) - removal, replacement of seals and installation").
3. Remove the fuel rail (see "Fuel rail engine 2111 (1.5i 8v) - removal, disassembly, assembly and installation").
4. Key by 13 mm we unscrew the three mounting nuts and remove the bracket.
5. Key by 13 mm we unscrew the two nuts securing the mounting eye (eye) and remove it.
6. Key by 13 mm loosen the lower bracket mounting nut and unscrew the upper bracket mounting nut.
7. Move the bracket to the side.
8. Key by 13 mm unscrew the nut of the upper mount of the right rod.
9. Key by 17 mm unscrew the nut of the upper fastening of the left rod.
10. Remove the intake pipe (see "Engine intake pipe 2111 (1.5i 8v) - removal and installation").
11. Key by 17 mm we unscrew the nut of the lower mount of the left rod and remove the rod.
12. Key by 13 mm unscrew the bolt of the lower mount of the right rod to the cylinder block.
13. Remove the right rod and spacer sleeve from the intake manifold stud.
14. Key by 13 mm with an extension, unscrew the four nuts of the upper mount and two nuts of the lower mount of the intake manifold and exhaust manifold (for clarity, shown on a removed cylinder head).
15. Remove the intake manifold.
16. Remove the exhaust manifold.
The material is posted on the online resource VazBook
17. Remove the gasket from the studs.
Comment.The gasket consists of two parts.
Installation
We install the exhaust manifold and intake manifold in the reverse order, replacing the gasket with a new one.