All articles about the device and repair of rear suspension elements of VAZ-2121 "Niva" cars and their modifications.
Rear suspension device The rear suspension device is shown in fig. 4-14. Pic. 4-14. Rear suspension: 1 - spacer sleeve; 2 - rubber bushing; 3 - lower longitudinal rod; 4 - lower insulating gasket of the...
Removal and installation of a back suspension bracket Removing Raise the rear of the car and place it on stands. Remove rear wheels. Disconnect the propeller shaft from the final drive gear flange. Disconnect the brake hydraulic hose...
Checking the technical condition of the front suspension Wash all parts thoroughly before checking. Protect rubber parts, bushings and protective coatings from solvents when washing. Springs Check the elastic characteristic of the...
Front and rear shock absorbers The device of shock absorbers of the front and rear suspensions made in association «AvtoVAZ» shown in fig. 4-18. Pic. 4-18. Shock absorbers of the front and rear suspensions: 1 -...
Checking shock absorbers on the stand To determine the performance of the shock absorber, check its working diagram on the dyno. Record working diagrams according to the instructions attached to the stand, after...
Dismantling and assembling the shock absorber After external washing, secure the shock absorber in a vise. Note. To fix the shock absorber and its parts in a vice, special jaws 67.7824.9513 001 are used. After pulling out the...
Checking the technical condition of shock absorber parts Rinse metal parts with kerosene and dry them, and rubber parts with warm water and wipe with a clean cloth. Carefully check that the parts comply with the following requirements:...