Clutch and its drive repair VAZ-21214

All articles on the device, principle of operation and repair of clutch units and its drive of VAZ-21214 Niva cars and their modifications.

Elements of the vehicle transmission
Transmission units: 1, 3 – front wheel drives; 2 – front axle; 4 – clutch; 5 – gearbox; 6 – front propeller shaft; 7 – intermediate shaft; 8 – transfer case; 9 – transfer case...

Clutch elements and its hydraulic drive
Clutch and its hydraulic drive: 1 – clutch release fork pusher; 2 – adjusting nut; 3 – lock nut; 4 – clutch release hydraulic drive slave cylinder; 5 – fork release spring; 6 –...

Clutch design features
The clutch is single-disk, dry, with a central pressure spring of the diaphragm type. It is located in an aluminum housing, bolted to the engine block and structurally integrated...

Adjusting the clutch release drive
Pedal, master and slave cylinders of the clutch release drive: 1 – adjusting nut; 2 – lock nut; 3 – release spring; 4 – working cylinder body; 5 – body plug; 6 – bleed nipple; 7 –...

Bleeding the clutch hydraulic drive
Attention! We carry out the work on a lift or inspection pit. We check the fluid level in the clutch hydraulic drive reservoir and add fluid if necessary. Remove the cap from the...

Removal the clutch hydraulic reservoir
We unscrew the cap of the tank.. …and using a rubber bulb we pump out the brake fluid from the reservoir. By loosening the hose clamp,… …we remove the hose from the tank fitting....

Removal the clutch master cylinder
By loosening the hose clamp,… …we remove the hose from the plastic fitting of the master cylinder. We drain the brake fluid from the clutch hydraulic reservoir into a container or...

Removal the clutch hydraulic slave cylinder
Attention! We carry out the work on an inspection pit or lift. We remove the release spring. Using pliers, remove the cotter pin from the hole in the pusher. Using a 13 mm socket...

Removal the flexible hose of the clutch hydraulic drive
Attention! We carry out the work on an inspection pit or lift. Using a 13 mm wrench, unscrew the tube fitting, holding the upper end of the hose with a 19 mm wrench. Using pliers,...

Replacing the driven and leading clutch discs
Remove the gearbox (see Removal the gearbox ). To make the clutch housing mounting bolts easy to unscrew, tap their heads with a copper hammer. We screw the clutch housing...

Removal the clutch release drive mechanisms
Remove the gearbox (see Removal the gearbox ). We remove the clutch release fork cover. Pull and remove the plug. We remove the clutch release bearing. We remove the spring from...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Transmission: Clutch VAZ-2114 (2004-2013)
➠ Transmission: Clutch VAZ-2106 (1976-2006)
➠ Transmission: Clutch VAZ-2107 (1982-2012)
➠ Transmission: Clutch VAZ-21011 (1974-1983)
➠ Transmission: Clutch VAZ-2109 (1984-1997)

Share with friends: