Steering of cars VAZ-21214

All articles about the device and repair of components and elements of the steering of VAZ-21214 "Niva" cars and their modifications.

Steering controls
Steering gear assembly with drive: 1 – bipod; 2 – medium thrust; 3 – pendulum arm bracket housing; 4 – lever axis; 5 – pendulum lever; 6 – bushing; 7 – adjusting nut; 8 – inner...
There is 1 comment

Features of the steering design
Steering – with mechanical connection, without booster. Steering mechanism – "globoidal worm – double-ridge roller", gear ratio of the reducer – 16.4. The steering trapezoid is...

Replacing the oil in the steering gear
Attention! We carry out the work on an inspection pit or lift. To check the oil level in the gearbox (in the photo the vacuum booster has been removed for clarity)… … use the "8"...

Adjusting the clearance in the engagement of the roller with the steering gear worm
Attention! We carry out the work on an inspection pit or lift. We make adjustments when we detect free play of the steering gear pitman arm. Before adjustments, it is necessary to...

Removal the side traction
Attention! We carry out the work on an inspection pit or lift. We hang up and remove the wheel. To remove the right lateral tie rod, turn the steering wheel all the way to the...

Removal the middle rod
Attention! We carry out the work on an inspection pit or lift. We remove the cotter pin with pliers.. …and using a 22 mm wrench, unscrew the nut securing the middle rod to the...

Replacing mud caps and tie rod ends
Mud caps and steering rod ends can be replaced on the vehicle. For clarity, we perform these operations on a removed rod. To replace the mudguard… … we knock it off with a soft...

Removal and disassembling the pendulum arm bracket
Attention! We carry out the work on an inspection pit or lift. Remove the right wheel. Press out the ball joints of the rods from the holes of the pendulum arm: middle (see...

Removal the steering wheel
Disconnect the negative cable from the battery. Using a slotted screwdriver, pry off the decorative trim on the horn switch cover… …and we take it off. Using a 24 mm socket,...

Removal the steering column
Remove the steering wheel (see Removal the steering wheel ). Remove the steering column trim covers (see Removal the three-lever steering column switch ). Remove the ignition...

Removal the steering gear and adjusting the clearance in the worm bearings
Attention! We carry out the work on an inspection pit or lift. We remove the bolt securing the fork of the lower cardan joint of the intermediate shaft of the steering gear to the...

Removal the bipod
Attention! We carry out the work on an inspection pit or lift. Using a 30 mm socket, loosen the bipod mounting nut. Remove the steering mechanism from the car (see Removal the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Steering VAZ-2109 (1984-1997)
➠ Chassis: Steering VAZ-2115 (1997-2012)
➠ Chassis: Steering VAZ-21061 (1976-2006)
➠ Chassis: Steering VAZ-2107 (1982-2012)
➠ Chassis: Steering VAZ-2112 (1999-2007)

Share with friends: