Car engine electrical equipment VAZ-21214

All articles about the installation and repair of electrical equipment of the engine (generator, starter, ignition, etc.) of VAZ-21214 Niva cars and their modifications.

Rechargeable battery
The cars are equipped with a lead starter battery 6-CT55A or its imported analogues. The battery case is made of translucent plastic with marks of the maximum and minimum...

Description of the generator design
Generator 371.3701: 1 – pressure sleeve; 2 – bushing; 3 – buffer sleeve; 4 – protective cover; 5 – rectifier block mounting screw; 6 – rectifier block; 7 – rectifier block valve;...

Checking the generator
Start the engine, let it run for a few minutes, then press the gas pedal, bring the crankshaft speed to 3000 min⁻¹. Turn on the high beam headlights, rear window heating, heater...

Removal and disassembly of the generator 9412.3701 injection engine
Disconnect the negative cable from the battery. Remove the oil pan protection plate and the right engine mudguard (see Removal the oil pan protection plate and mudguards of the...

Removal the generator 371.3701
Attention! We carry out the work on an inspection pit or lift. Remove the oil pan protection plate and the right engine mudguard (see Removal the oil pan protection plate and...

Description of the starter design
Starter 35.3708 complete: 1 – drive side cover; 2 – retaining ring; 3 – limiting ring; 4 – drive gear; 5 – overrunning clutch; 6 – leash ring; 7 – rubber plug; 8 – drive lever; 9...

Removal the starter
Removing starters 5722.3708 and 35.3708 is similar. We will show this operation using the example of 5722.3708. Disconnect the negative cable from the battery. We dismantle the...

Disassembling the starter 5722.3708
We clean the starter from dirt and install it in a vice. Using a 13 mm spanner, unscrew the nut on the lower terminal of the traction relay. We remove the wire. Using an 8 mm...

Disassembling the starter 35.3708
We clean the starter from dirt and install it on the workbench. Using a 13 mm wrench, loosen the nut securing the wire to the traction relay... ...and disconnect the wire tip. To...

Carburetor electromagnetic valve control system
Wiring diagram of the carburetor electromagnetic valve control system: 1 – ignition switch; 2 – ignition relay; 3 – ignition coil; 4 – control unit;5 – electromagnetic valve; 6 –...

Removal the carburetor electromagnetic valve control unit
Turn off the ignition. We disconnect the block from the control unit of the electromagnetic valve of the carburetor. Using an 8 mm head, unscrew the two nuts securing the block to...

Removal the carburetor air damper cover indicator lamp and its switch
Disconnect the negative cable from the battery. Remove the instrument cluster (see Removal the instrument cluster ). We slide the rubber cover through the instrument cluster...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Engine electrics VAZ-21051 (1979-2010)
➠ Power unit: Engine repair VAZ-2107 (1982-2012)
➠ Power unit: Engine repair VAZ-2101 (1970-1983)
➠ Power unit: Engine repair VAZ-2106 (1976-2006)
➠ Power unit: Engine repair VAZ-2110 (1995-2007)

Share with friends: