Repair of clutch and its drive VAZ-21213

All articles on the device, principle of operation and repair of clutch units and its drive of VAZ-21213 Niva cars.

Clutch device
The clutch device is shown in Fig. 3-1. The clutch release fork 11 can be installed in two types: with a flat or wire spring. Fig. 3-1. Clutch assembly: 1 - bleed nipple; 2 -...

Possible clutch malfunctions, their causes and methods of elimination
Incomplete disengagement of the clutch (clutch "leads") Cause of malfunction Method of elimination 1. Increased clearances in the clutch release drive. 1. Adjust the clutch...

Adjusting the clutch release drive
The following adjustments are made in the clutch release drive: a gap of 0.1-0.5 mm is set between the pusher and the piston of the master cylinder (Fig. 3-2). This gap, necessary...

Bleeding the clutch hydraulic drive
0 Air getting into the clutch hydraulic drive is indicated by incomplete disengagement of the clutch, as well as "softness" and "failures" of the clutch pedal. To remove air from...

Removal and installation the clutch
Removal First remove the gearbox (see " Transmission "). Loosen the bolts and remove the clutch housing assembly with the pressure plate. In doing so, do not lift this unit by the...

Clutch control
The clutch is checked on a base that imitates the engine flywheel and has a metal intermediate ring 4 (Fig. 3-5) 8.2 mm thick, replacing the driven disk. Having secured the clutch...

Removal and installation the working and master cylinders of the clutch release drive
First of all, drain the working fluid. To do this, put one end of the hose on the air release nipple 9 ( fig. 3-3 ) of the working cylinder, and lower the other into a clean...

Disassembly, inspection, repair and assembly of the master and slave clutch cylinder
Master cylinder Unscrew plug 3 (Fig. 3-8), remove protective rubber cap 7 and retaining ring 8. This will allow you to remove piston 9, sealing ring 10, floating piston 11 with...

Checking the clutch master cylinder on the stand
Checking the tightness of the rear sealing ring Mount the master cylinder on the stand (Fig. 3-10), ensuring a good seal between the cylinder flange and the mating surface of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Transmission: Clutch VAZ-2107 (1982-2012)
➠ Transmission: Clutch VAZ-21061 (1976-2006)
➠ Transmission: Clutch VAZ-21051 (1979-2010)
➠ Transmission: Clutch VAZ-2101 (1970-1983)
➠ Transmission: Clutch VAZ-2110 (1995-2007)

Share with friends: