Car transfer case VAZ-21214

All articles on the device and repair of transfer case units of VAZ-21214 Niva cars and their modifications.

Elements of the transfer box
Transfer case with drive: 1 – differential lock clutch fork; 2 – differential lock fork rod; 3 – protective cover of the rod; 4 – lock washer; 5 – lever axle bushing; 6 – lever...

Design features of the transfer case
The transfer case is used to change the torque value and distribute it between the front and rear axles. The box has two gears with gear ratios of 1.200 and 2.135. The front and...

Determining the Causes of Vibration and Aligning the Transfer Case
We remember the vehicle speed and engine speed at which vibration occurs in the transfer case mounting area. With the vehicle stationary, we shift the gearbox and transfer case...

Changing the oil in the transfer case
Attention! We carry out the work on an inspection pit or lift. Before changing the oil, it is necessary to warm up the transmission by driving the car for at least 10 km. Using a...

Replacing the transfer case shaft seals
Attention! We carry out the work on an inspection pit or lift. We replace the seals of the drive shafts of the front and rear axles by disconnecting the flanges of the cardan...

Removal the speedometer drive gear housing and speed sensor
Attention! We carry out the work on an inspection pit or lift. Disconnect the flexible speedometer drive shaft from the transfer case (see Removal the flexible shaft of the...

Removal the transfer case suspension bracket
Attention! We carry out the work on an inspection pit or lift. To ensure that the transfer case returns to its original position after replacing the suspension bracket,… …with a...

Replacing the differential lock indicator light switch
We replace the differential lock indicator light switch from inside the car. We remove the floor tunnel lining (see Removal the floor tunnel lining ). Using a Phillips...

Removal the transfer case
Attention! We carry out the work on an inspection pit or lift. In the car interior, remove the wires from the differential lock indicator light switch (see Replacing the...

Disassembling the transfer case
Disconnect the intermediate shaft from the flange of the transfer case drive shaft (see Removal the intermediate shaft ) We drain the oil from the transfer case and clean it from...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends: