A fully fueled and equipped vehicle with a load of 75 kg on the driver's seat is placed on a flat horizontal surface 5 m from a smooth wall or any screen (plywood shield measuring about 2x1 m, etc.) so that the car's axis is perpendicular to it. Before marking the screen, make sure that the air pressure in the tires is normal, and then rock the car from the side so that the suspension springs are installed.
Draw vertical lines on the screen (Fig. 169): the axial 0 and lines passing through the points corresponding to the centers of the headlights. These lines must be symmetrical relative to the axial line of the car. At a height corresponding to the distance of the centers of the headlights from the floor, draw line 1 and below it by 80 mm line 2 of the centers of the light spots. Turn on the low beam. Sequentially, first for the right headlight (the left one is covered with a piece of cardboard or dark fabric, or turned off), and then for the left (the right one is closed) adjust with screws 3 (see fig. 168) and 4 light beams of headlights. In adjusted headlights the upper border of the light spots should coincide with line 2 (see fig. 169), and the intersection points of the horizontal and inclined sections of the light spots are with lines and
Check whether the high beam headlights turn on.
