Carburetor control drive 2105-1107010
1 – air damper control rod handle; 2, 17 – seals; 3 – air damper drive rod; 4, 14 – return springs; 5 – return spring mounting screw; 6 – transverse thrust; 7 – intermediate lever; 8 – longitudinal thrust; 9 – traction rod mounting bracket; 10 – roller mounting bracket; 11, 13 – levers; 12 – roller; 15 – lock washer; 16 – throttle control pedal
1. When pedal 16 is fully depressed, the throttle valve of the first chamber should be fully open and the throttle lever should not have any additional travel. When the pedal is released, the throttle valve should be fully closed. If this is not the case, the position of the pedal and throttle valve can be adjusted by changing the length of the rod 8, by twisting or screwing the tip.
2. At the same time, check and, if necessary, adjust the length of rod 6. The center distance of its tips should be 80 mm.
3. The air damper drive rod 3 and its casing must be secured so that when the handle 1 is fully extended, the damper is fully closed, and when the handle is recessed, it is fully open.
[Information copied from the portal: vazbook.ru]