Engine oil type: "LUKOIL-Arctic" (5W-30, 5W-40; SG/CD), "YAR-Marka Super" (5W-30, 5W-40; SG/CD), "Novoil Sint" (5W-30; SG/CD), "ESSO ULTRA" (10W-40; SJ/SH/CD), "ESSO UNIFLO" (15W-40; SJ/SH/CD).
If you decide to use a different brand of oil, first flush the engine lubrication system with flushing oil or oil that will be poured into the engine. To do this, after draining the old oil, fill in new oil to the lower mark of the indicator (probe). Start the engine and let it idle for 10 minutes. Drain the oil and only then change the oil filter. Now you can fill in new oil.
Checking is recommended to be carried out on a viewing ditch, a lift or by lifting the car with a jack and placing it on supports.
We recommend draining the oil immediately after driving, while the engine is warm. If the engine is cold, start it and warm it up to operating temperature (80°С).
Attention! Do not dump used oil on the ground.
1. From the bottom of the car, unscrew the drain plug on the engine crankcase, after substituting a container under it, and drain the used oil. Close the drain plug.
2. Unscrew the oil filter with a special wrench. If there is no such key, and the filter cannot be unscrewed by hand, pierce the filter housing with a screwdriver and unscrew the filter using it as a lever.
3. Lubricate the O-ring of the new filter with engine oil.
4. Screw on the new filter by hand without using a tool.
5. Fill in new oil, checking its level on the pointer (dipstick) (see subsection 2.18.). Start the engine and let it idle for a few minutes. Stop the engine, check the oil level and top up if necessary.