Advice: To avoid mixing up the terminals on the ignition coil (ignition module), it is more convenient to replace high-voltage wires one by one.
Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Disconnect the high-voltage wires from the spark plugs.
3. Disconnect the high-voltage wire tips from the ignition coil (module).
4. With a multimeter (in ohmmeter mode) we measure the resistance of the wires.
5. The resistance of serviceable wires (depending on the length) should be within 3.5-10.0 kOhm
Recommendation: High-voltage wires should be replaced as a set.
6. Connect the wires to the spark plugs and the ignition coil (module) in accordance with the cylinder numbers marked on the wires and on the ignition coil (module) (see "Ignition module (coil) for engines 2111 and 21114 (8v) - checking and replacement").
Warning! Connect the wires to the ignition module only in accordance with the cylinder serial number. The wire insulation is marked with the cylinder serial number.